泵概述
White Knight PPMC 微型泵使液体接触部分为PTFE和PFA可能使用在高纯化学品中。 该泵能够达到300毫升/分钟的流量和流量压力160 psi。 特点是电磁阀控制每个吸入和排出。
单击并拖动以旋转
特点和优点
- 非金属的液体通路
- 达到 300 ml/min 的流速
- 最高 11 公斤（160PSI) 液体排出压力
- 最高 7 公斤（100PSI) 压力下消耗的气量
- 最高100度
- 最多吸液高度为0.5米
- 干打的能力
- 内置电磁阀的板载控制器
- 24VDC使用5针电源和信号输入
- 模拟或数字的外部输入控制、或循环周期的内部控制
- 各种液体连接选项的
- 占用空间小
- 安装在任何方向的
- 易于安装
泵操作
两个电磁阀控制吸入和释放动作的迷你泵。 而装有弹簧的检查使泵可以安装在任何方向,向上流动的路径是首选的,更好地抽空气泡的液体行和改善的重复性。
Pin |
Function |
Connection Type |
Connector Diagram |
|---|---|---|---|
1 |
Power | 24 VDC Power Supply |  5 pin Turck EuroFast style connector |
2 |
Analog Input | 0-5 VDC Analog input to set cycle rate. - 0-1 VDC = Pump Off - 1-5 VDC = Pump On = 0-400 CPM |
|
3 |
Common Ground | 0 VDC Ground | |
4 |
Valve Control Actuate Suction |
Sink Type Signal - 24 VDC = Not Active - 0 VDC = Active |
|
5 |
Valve Control Actuate Discharge |
Sink Type Signal - 24 VDC = Not Active - 0 VDC = Active |
Operation |
Description |
Notes |
|---|---|---|
| Analog Input | Pump will stop cycling if analog input is 1 VDC or less. If analog input is 1-5 VDC, cycle rate equals: 100*Voltage-100 | Pump should be powered on and valve controls disconnected. |
| External Valve Control |
When pump is powered on and analog input is less than 1 VDC, solenoids and cycle rate can be controlled from external PLC. | Pump should be powered on. |
| Fixed Cycle Rate* | Pump cycles at desired rate when on. It continues cycling until powered off. |
Pump should be powered on |
*Offered by request only
泵性能曲线
* 300 mL/min at wide open flow path. Performance measurements shown are using a back pressure regulator to simulate a pressurized system. Results may vary.
泵温度范围
泵尺寸图
尺寸单位为英寸的图（毫米）
泵规范
Model |
PPMC300 |
|---|---|
| Dispense Volume per Stroke |
~0.75 ml* |
| Max Flow | 300 ml/min |
| Max Fluid Pressure | 11 bar (160 psi) |
| Max Air Pressure | 7 bar (100 psi) |
| Cycles per min | 400 max |
| Air Consumption | 1 SCFM |
| Fluid Path Materials |
PTFE, PFA |
| Max Dry Suction Lift |
508 mm (20 in) |
| Solenoid Valves | 2x 24V Manifold Valves 0.7 CV |
| Turck Connector | 5 Pin O-ring Sealed |
| On-Board Controller |
Power: 24 VDC Max Power Consumption: 6 Watts Internal I/O: • Two 24 VDC Valve outputs External I/O: • One 0-5 VDC analog input. • Two NPN Compatible Signal Input |
* Stroke length varies depending on operation.
